1-Day Concrete Floor Coatings for Lifetime Value
Scroll below to see featured projects we completed in Mt Vernon.
Better than epoxy in every way – stronger, longer lasting and more cost effective over time.
Epoxy takes almost full week to cure, polyurea can be installed in just one day and is ready for heavy use in two.
While our competitors offer one to 5-year warranties, we proudly stand by a LIFETIME warranty.
FloorTech Concrete Coatings is an exclusive installed of Penntek coatings in Mt Vernon, Virginia. Our PURE polyurea is the best choice for longevity of coating, quality of installation and we offer extensive customization of your concrete coatings.
Completed on March 19, 2024, near Mt. Vernon, this project involved coating a residential garage floor with a ‘silver creek’ chip flake color, offering a modern look. The polyaspartic, polyurea coating was chosen for its outstanding durability and quick drying.
The garage’s concrete was in good condition, with minor cracks that were carefully repaired and polished. This effort added another satisfied customer in Fairfax Station, enjoying a resilient and beautifully coated garage floor.
This garage floor coating project near Mt. Vernon, was completed on February 29, 2024. Opting for a ‘domino’ chip flake color, the client aimed for a bold effect. We used a polyaspartic, polyurea coating for its durability and rapid cure rate.
The concrete was in satisfactory condition, with usual wear and a few small cracks, which were addressed by repairing and polishing. This preparation led to another satisfied customer in Annandale, with a durable and aesthetically pleasing garage floor.
Although epoxy offers initial cost savings, polyurea is better choice in terms of overall performance and long-term cost-effectiveness, owing to its durability and lower maintenance requirements. The decision between epoxy and polyurea ultimately hinges on your needs. Go with polyurea if want a long-lasting, durable coating with minimal upkeep. Alternatively, if you’re pursuing a shorter-term solution or operating on a tighter budget – epoxy might suit your needs. For those with the requisite skills and time, a DIY approach could also be considered.
Typically, the cost of materials and labor varies, averaging around $6.50 per square foot for larger areas like 900 square feet, and going up to $9.00 per square foot for smaller spaces of around 300 square feet.
Polyurea and epoxy are both used for coating concrete, but they’re quite different. Polyurea is stronger and lasts longer, about 15 years, compared to epoxy’s 3-5 years. It bonds deeply with concrete, making it less likely to chip or peel. Epoxy, while protective, just sits on the surface and can wear out faster, especially with heat and sunlight. When applying polyurea, the surface needs more preparation, but this makes it more durable. In simple terms, polyurea is like a stronger, longer-lasting protective layer for your concrete surfaces. Learn more about the difference between polyurea and epoxy.
It is always a good idea to consult your HOA regarding rules about painting or installing coatings in outdoor areas visible from the outside. Typically, this would only apply to driveway and sidewalk coatings. We advise you to check with your HOA, review their documentation, and see whether there is any mention of concrete coatings. If there isn’t, you should be clear to have your coating installed.
Epoxy and some other polyurea coatings can only be installed during warmer months of the year. But, our polyurea coating can be installed year-round even in winter, and still only takes a day for installation.
Penntek coating is only available for professionally trained Penntek dealers like FloorTech Concrete Coatings.
Choose our #1 concrete coating to provide you with attractive, low-maintenance, and durable floors for high-traffic areas.
COPYRIGHT © 2024 FloorTech Concrete Coatings | ALL RIGHTS RESERVED.
Send a message, and we will get back to you as soon as we can.
We are here to resolve your doubts or concerns.